POWR
Installing the cylinder head
1. Install a new gasket and the cylinder
head, and then tighten the bolts to the
specified
torques
shown.
5
8
1
7
4
9
E
CAUTION:
Do not reuse the cylinder head gasket,
always replace it with a new one.
NOTE:
• Apply engine oil to the cylinder head bolts
before installation.
• Tighten the bolts to the specified torques in
3 stages.
• Make a mark a on cylinder head bolts (M9)
and the cylinder head, and then tighten the
bolts 60° from the mark.
Cylinder head bolt 1–6 (M9):
1st: 15 N·m (1.5 kgf·m, 11.1 ft·lb)
2nd: 29 N·m (2.9 kgf·m, 21.4 ft·lb)
3rd: 60°
Cylinder head bolt 7–9 (M6):
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 12 N·m (1.2 kgf·m, 8.9 ft·lb)
Checking the oil pump
1. Remove the oil pump screws 1 and dis-
assemble the oil pump.
5-47
Power unit
in
the
sequence
6
2
3
a
60˚
S6AG5440
5
2. Check the inner surface of the oil pump
case. Replace the oil pump assembly if
scratched.
3. Measure the oil pump rotor clearances
as shown. Replace the oil pump assem-
bly if out of specification.
a
5
1
S6AG5430
b
c
S6AG5420
6AG3J11