Installing The Cylinder Head - SELVA MARINE Grey Whale 200 EFI Service Manual

POWR
5. Connect the flushing hose and fasten it.
NOTE:
See the hose routing (4-3) and exploded dia-
gram (5-43).
6. Tighten the knock sensor to the specified
torque, and then fasten the knock sensor
lead 5 and flushing hose 6 as shown.
5
6
NOTE:
Fasten the knock sensor lead so that it is
taut.
Knock sensor:
32 N·m (3.2 kgf·m, 23.6 ft·lb)

Installing the cylinder head

1. Install the grommets and collars into the
cylinder block.
NOTE:
See the exploded diagram (5-43).
2. Install new gaskets and the cylinder
heads, and then tighten the bolts to the
specified torques
shown.
5-55
Power unit
5
6
S6AL5450
in the sequence
PORT
6
5
2
1
4 3
8
7
9
0
A
CAUTION:
Do not reuse the cylinder head gaskets,
always replace them with new ones.
NOTE:
• Be sure to install the port and starboard cyl-
inder head gaskets onto the correct cylin-
der heads.
• Apply engine oil to the cylinder head bolts
before installation.
• Tighten the M10 bolts 1–8 to the speci-
fied torques in 6 stages. However, when
loosening the bolts in the 3rd stage, loosen
them in the opposite order used for tighten-
ing. In the 6th stage, make a mark a on the
M10 bolts and the cylinder heads, and then
tighten the bolts 90° from the mark.
• After tightening the M10 bolts 1–8 has
been completed, tighten the M8 bolts 9–A
to the specified torques in 2 stages.
UP STBD
5
6
1
2
4
3
7
8
9
0 A
a 90˚
(T55)
S6P25910E
6AL3J11