Acura 2002 RSX Service Manual page 996

Hide thumbs Also See for 2002 RSX:

Table of Contents

Apply primer (3M N-200, or equivalent) to the

inside face of the rear wiridow (A), and glue the

m o l d i n g ( B ) :

. With the printed dots (C) on the upper and side

portions of the rear window as a guide, glue the

molding around the edge of the rear window.

. B e f o r e i n s t a l l i n g t h e m o l d i n g , f o l d t h e e d g e o f t h e

adhesive backing on the double-faced adhesive

t a p e . A f t e r i n s t a l l i n g t h e m o l d i n g , p u l l t h e

adhesive backing away, then glue the molding

. Be careful not to touch the rear window where

adhesive will be applied.

,///'/,,/ 1 Appl,t primet here.

14. Glue the upper seal {A) with adhesive tape (B}

(3M 4215, or equivalent) onto the upper portion of

t h e m o l d i n g ( C ) :

. B e s u r e t h e a l i g n m e n t m a r k ( D ) o f t h e s e a l l i n e s

u p w i t h t h e a l i g n m e n t m a r k ( E ) o f t h e w i n d s h i e l d '

. Be careful not to touch the window where

adhesive will be aPPlied

Glue the upper fasteners (A) and lower fasteners

{B) with adhesive tape (3M 5312, or equivalent) to

the hatch as shown.

Fastener Locations

A>:Fastener,2 B > :Fastener,2

Chapters

Table of Contents