Acura 2002 RSX Service Manual page 1317

v
Transmitter Test
NOTE:
. lf the doors unlock or lockwith thetransmitter, but
the LED on the transmitter does not come on, the LED
is faulty; replace the transmatter.
. l f a n y d o o r o r t h e h a t c h i s o p e n , y o u c a n n o t l o c k t h e
doors with the transmitter'
. lf you unlocked the doorswith the transmitter, butdo
not open any of the doors within 30 seconds, the
doors relock automaticallY.
. The doors do not lock or unlock with the transmitter if
the ignition key is inserted in the ignition switch.
1. Open the transmitter and check tor water damage.
. l f y o u f i n d a n y w a t e r d a m a g e , r e p l a c e t h e
transmitter.
. l f t h e r e i s n o w a t e r d a m a g e , g o t o s t e p 3 .
2. Replace the transmitter battery (A) withanewone,
and try to lock and unlock the doors with the
transmitter.
. l f t h e d o o r s l o c k a n d u n l o c k , t h e t r a n s m i t t e r i s O K .
' l f t h e d o o r s d o n ' t l o c k a n d u n l o c k , g o t o s t e p 3
Reprogram the transmitter, then try to lock and
unlock the doors.
. l f t h e d o o r s l o c k a n d u n l o c k , t h e t r a n s m i t t e r i s O K .
. l f t h e d o o r s d o n ' t l o c k a n d u n l o c k , r e p l a c e t h e
transmitter.
Transmitter Programming
Storing transmitter codes:
The codes of up to three transmitters can be stored in
the keyless receiver unit memory. (lf a fourth code is
stored, the code which was input first will be erased.)
NOTE: lt ls important to maintain the time limits
between the steps. Make sure the doors and the hatch
are closed.
1. Turn the ignition switch ON (ll).
2. Within 1 to 4 sec,, push the transmitter lock or
unlock button with the transmitter aimed at the
receiver under the audio unit.
3. Within 1 to 4 sec., turn the ignition switch OFF.
4, Within 1 to 4 sec.. turn the ignition switch ON (ll).
5. Within 1 to 4 sec., push the transmitter lock or
unlock button with the transmitter aimed at the
receiver under the audio unit.
6. Within 1 to 4 sec., turn the ignition switch OFF.
7. Within 4 sec., turn the ignition switch ON (ll).
8. Within 1 to 4 sec., push the transmitter lock or
unlock button with the transmitter aimed at the
receiver under the audio unit.
9. Within 1 to 4 sec., turn the ignition switch OFF.
10. Within 4 sec., turn the ignition switch ON (lll.
'l'1. within 1 to 4 sec.. push the transmitter lock or
unlock button with the transmitter aimed at the
receiver under the audio unit.
12. Contirm you can hear the sound of the door lock
acluators. Within 1 to 4 sec.. push the transmitter
lock or unlock button again.
13. Within 10 sec., aim the remaining transmitters (up
to two auditional ones) whose codes you want to
store at the receiver, and press the transmitter lock
or unlock buttons.
Coniirm that you can hear the sound of the door
lock actuators after each transmitter code is stored.
1 4 . T u r n t h e i g n i t i o n s w i t c h O F F , a n d p u l l o u t l h e k e y .
15. Confirm proper operation ofthe transmitters.
22-165