Acura 2002 RSX Service Manual page 1426

sRs
DTC Troubleshooting (cont'd)
7. Unbuckle the front passenger's seat belt.
Check resistance between the No. 1 and No. 2
terminals of the front passenger's seat belt buckle
switch 3P connector. There should be 0- 1 Q.
Check resistance between the No. 1 and No.3
terminals of the same connector. There should be
an open circuit, or at least 1 M Q .
FROT{T PASSENGEN'S SEAT BELT
EUCKLE SWTTCH 3P CONNECTOR
Terminal side ol male terminals
Terminal side ol male terminals
ls the tesistance as specitied?
YES- Go to step 8.
NO-Replace the front passenger's seat belt buckle
assembly, and clearthe DTC.I
23-80
v
8. Check resistance between the No. 1 terminal of the
floor wire harness 3P connector and body ground.
T h e r e s h o u l d b e 0 - 1 Q .
FLOOR WIRE HARNESS 3P CONNECTOR
Wire side ot temale terminals
ls the resistance as specified?
YES-Go to step 9.
NO-Open in the floor wire harness or poor ground
connection at G501. lf G501 is OK, replace the floor
wire harness.l
Disconnect the negative cable from the battery.
Disconnect SRS unit connector B (8P)from the SRS
U N I I ,
9 .
1 0 .
I