Acura 2002 RSX Service Manual page 1281

3 .
4 .
Power Mirror Switch Test
'1.
Carefully pry out the driver:s switch panel (see
page 20-62).
2. Disconnect the 13P connector (A) from the power
mirror switch {B).
Remove the two screws and the switch.
Check for continuity between the terminals in each
switch position according to the table.
Mirror Switch:
Defogger Switch lcanadal:
\
Terminal
;;;;
tl\
8
ON
OFF
o-
-o
lf the continuity is not as specified. replace the
switch.
6 1 0 1 1
1 2 1 3
Power Mirror Actuator Test
1 . R e m o v e t h e d o o r p a n e l ( s e e p a g e 2 0 - 4 ) .
2. Disconnect the 3P (or 6P) connector (A) f rom the
power mirror actuator (B).
B
Wire side of female termanals
Check actuator operation by connecting power and
ground according to the table.
4. lf the mirror fails to work properly, replace the
mirror actuator,
Defogger Test {Canada):
5. Check for continuity between the No. l and No.
terminals ofthe 6P connector. There should be
continuity.
6. lf the continuity is not as specified, replace the
mirror actuator.
usA
/:\
(ffi)
[ ] :Canada
22-129