5. Reassemble the clutch in the reverse order of
disassemblv. and note these items:
. lnstallthe field coil with the wire side facing
down, and align the boss on the field coilwith the
hole in the compressor.
. Clean the rotor pulley and compressor sliding
surfaces with contact cleaner or other
non-petroleum solvent.
. Install new snap rings, note the installation
direction, and make sure they are fully seated in
the groove.
' Make surethatthe rotor pulleyturns smoothly
after it's reassembled.
. Route and clamp the wires properly or they can
be damaged by the rotor pulley.
21-57