Acura 2002 RSX Service Manual page 1456

sRs
DTC Troubleshooting (cont'dl
DTC 15-2: Faulty Side Airbag Cutoff Indicator
Circuit
1. Make sure nothing is on the front passenger's seat.
2. Erase the DTC memory (see page 23-23).
3. Turn the ignition switch ON {ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Turn the ignition switch OFF, and go to slep
NO - Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23]..
NOTE: This DTC may have been caused by turning
the ignition switch ON (ll)with the gauge assembly
disconnected.
4. Turn the ignition switch ON (ll), and check that the
side airbag cutoff indicator comes on.
Does the side airbag cutott indicator come on?
YES-Go to step 5.
NO Go to step 6.
5. Make sure the side airbag cutoff indicator goes off
after 5 seconds.
Does the side aitbag cutotf indicator go off atter 5
seconds?
YES Faulty OPDS unit or SRS unit; replace the
OPDS unit (see page 23-140). lfthe problem is still
present, replace the SRS unit (see page 23- 138). t
NO- Go to step 32.
6. Turn the ignition switch OFF.
23-110
7 . Check the No. 10 (7.5A)fuse in the under-dash
fuse/relay box.
ls the f use OK?
YES - Go to step L
N O R e p a i r t h e s h o r t t o g r o u n d i n t h e N o . 1 0 { 7 . 5 A )
fuse circuit.I
Disconnect the OPDS unit harness 8P connector {A)
from the OPDS unit (B) {see page 23-140).
Turn the ignition switch ON (ll).
Check for voltage between the No. 3 terminal of the
OPDS unit harness 8P connector and body ground.
There should be battery voltage.
OPDS UNIT HARNESS 8P CONNECTOR
Wire side of female terminals.
ls there battery voltage?
YES -'Go to step 1 1.
NO Go to step 23.
I
9 .
1 0 .