Table of Contents
Advertisement
)
DTC 1$3: Faulty OPDS Sensor
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on tor about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to steo 3.
NO Intermiftent failure. system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23l..
3. Check the connection at the OPDS sensor harness
connector and the OPDS unit connector.
Are the connections OK?
YES Go to steD 4.
NO Reconnect the OPDS sensor harness
connector, and clear the DTC.I
4. Replace the OPDS sensor/seat back foam (see page
20-76). and reinitialize the OPDS system (see page
23-241.
5. Erase the DTC memory, then check for DTC 15-3.
ls DTC 15-3 indicated?
YES Replace the OPDS unit (see page 23-140).
NO System is OK.l
23-115
Advertisement
Chapters
Table of Contents
Troubleshooting
