F R O N T L M P A C T S E N S O R R E P L A C E M E N - Acura 2002 RSX Service Manual

Front lmpact Sensor RePlacement
Removal
1. Disconnect the battery negative cable, and wait at
least 3 minutes before beginning work.
2. Remove the front inner fender (see page 20-1021.
3. Disconnect the engine compartment wire harness
2P connector {A), and remove the two Torx bolts (B)
using a Torx T30 bit, then remove the front impact
sensor (C).
!
rS
lnstallation
1. Install the new front impact sensor with new Torx
bolts {A), then connect the engine compartment
wire harness 2P connector (B)to the front impact
sensor (C).
A
9.8 N.m
ll.0 kgf.m,7.2lbf.ftl
Reconnect the battery negative cable.
After installing the front impact sensor, confirm
proper system operation: Turn the ignition switch
ON (ll): the SRS indicator should come on for
about 6 seconds and then go off.
23-141