Acura 2002 RSX Service Manual page 1410

sRs
DTG Troubleshooting {cont'd)
DTC 4-4: Short to Power in Front Passenger's
Seat Belt Tensioner
Special Tools Required
. sRS inflator simulator 07sAz-TB4o1'lA
. SRS simulator lead C 07TAZ-S2501 14
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-231.
2. Turn the ignition switch ON fll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES- co to step 3.
NO - Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23L
3. Turn the ignition switch OFF. Disconnectthe
battery negative cable. and wait for 3 minutes.
4. Disconnect the front passenger's seat belt
tensioner 2P connector from the floor wire
harness (A).
AZ-S25011A
Connect the special tool (2 Q connector)tothe
floor wire harness 2P connector.
23-64
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 4-4 indicated?
YES Go to step 9.
NO Shon to power in the front passenger,s seat
belt tensioner; replace the front passenger,s seat
belt (see page 23-4).I
L Disconnect the battery negative cable, and wait for
3 minutes.
10. Disconnect the floor wire harness 4P connector (A)
from the dashboard wire harness.
tril
,-,__,-vJ
07xAz-s230100
1 1 .
07sAz-T84011A
Connectthespecial tool (2 0 connecto rs) to the
dashboard wire harness 4P connector.
Reconnect the battery negative cable.
Erase the DTC memory.
Read the DTC.
ls DTC 4-4 ind icated?
YES Go to step 15.
NO - Short to power in the floor wire harness;
replace the floor wire harness.l
t 2 ,
1 3 .
1 4 .