Acura 2002 RSX Service Manual page 1396

SRS
DTC Troubleshooting (cont'dl
DTC 3-4: Short to Power in Driver's Seat Belt
Tensioner
Special Tools Required
. SRS inflator simulator 07SAZ-TB4011A
. SRS simulator lead C 07TAZ-S25011A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO - Intermiftent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-231.
3. Turn the ignition switch OFF. Disconnectthe
battery negative cable. and wait for 3 minutes.
4. Disconnect the driver's seat belt tensioner 2P
connector from the floor wire harness (A).
07TAZ-3250'ltA
Connect the special tool (2 0 connector)to the
floor wire harness 2P connector-
23-50
6. Reconnectthe battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 3-4 indicated?
YES- Go to step 9.
NO Shortto power in the driver's seat belt
tensioner; replace the driver's seat belt (see page
23-41.a
9. Turn the ignition switch OFF. Disconnectthe
battery negative cable. and wait for 3 minutes.
10, Disconnect the floor wire harness 4P connector (A)
from the dashboard wire harness.
1 1. Connect the special tool (2 Q connectors) to the
dashboard wire harness 4P connector.
12. Reconnect the battery negative cable.
Erase the DTC memory.
Read the DTC.
ls DTC 3-4 indicated?
YES Go to step 15.
NO-Shortto power in the floorwire harness;
replace the floor wire harness.l
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
1 3 .
1 4 .