Acura 2002 RSX Service Manual page 1042

Front Seat Disassembly/Reassembly - Passenger's
SRS components are located in this area. Review the SRS component locations (see page 23-'10) and the precautions
and procedures (see page 23-1 1) in the SRS section before performing repairs or service.
NOTE:
. Take care not to tear the seams or damage the seat covers.
. Put on gloves to protect your hands.
. When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
. For seat cushion removal and installation procedures referto Front Seat Cover Replacement {see step 2 on page 20-
7 6 ) .
. Apply multipurpose grease to the moving portion ofthe seat track.
. To preventwrinkles in the seat cushion cover, stretch the material evenly over the pad.
. Adjust the rear seat access cable.
. Make sure the rear seat access cable is connected properly on each portion.
. Replace any damaged clips.
SEAT.BACK
Unzip the seat back cover.
OPDS HARNESS
CENTER
INNER
COVER
1 0 x 1 . 2 5 m m
47 N.m ('1.8 kgf'm,
3s rbf.ft)
SEAT CUSHION
i ' ,
iir---'
--1
li\ r,
, . \ ' \
H i i
RECLINE KNOB
RECLINE COVER
SPB'NG
20-75