Acura 2002 RSX Service Manual page 781

Hide thumbs Also See for 2002 RSX:

Table of Contents

Lubricate the threads of the shafts, the new

locknuts, and the new ionical spring washers with

Install the new conical spring washers (A)with

facing stamped mark side up in the direction shown,

and install the new mainshaft locknut (B), the new

countershaft locknut (C), and the new secondary

shaft locknut (D).

Tighten the locknuts to 167 N.m (17.0 kgf.m,

123 tbf.ft).

' Be sure to installthe conical spring washers in

the direction shown.

. Use a torque wrench to tighten the locknut. Do

not use an impact wrench.

. Countershaft and secondary shaft locknuts have

leit-hand threads.

Remove the special tool from the mainshaft.

Stake the locknuts into the shafts with a punch.

15. lnstallthe control level (A) on the control shaft (B),

and install the bolt with the new lock washer (C),

then bend the lock tab of the lock washer against

the bolt head.

6 x 1 . 0 m m

{1.4 kgf m, 10 lbf ft)

Set the park lever in the [E position. then verify that

the park pawl (A) engages the park gear (B).

lf the park pawl does not engage fully, check the

distance (C) between the pawl shaft (D) and the

park lever roller pin (E) (see page 14-188).

Tighten the lock bolt, and bend the lock tab of the

lock washer (F) against the bolt head.

6 x l , 0 m m

{1.'l kgf.m,

Chapters

Table of Contents