Table of Contents
Advertisement
sRs
DTC Troubleshooting (cont'dl
DTC 13-3: No Signal from the Driver's Side
lmpact Sensor
Special Tools Required
. SRS inflator simulator 07SAZ-T84011A
. SRS simulator lead H o7YAZ-S3AA100
1. Erase the DTC memory (see page 23-23).
2. Turn the jgnition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO- Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-231.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minules.
4. Check the connection between the floor wire
harness 2P connector and the driver's side impact
sensor.
ls the connection OK?
YES Go to step 5.
NO Replace the driver's side impact sensor
and/or the floor harness, as needed (see page 23-
1 3 9 ) . r
23-100
5. Disconnectthe driver's side airbag and front
passenger's side airbag 2P connectors (A), and
disconnect both seat belt buckle tensioner 4P
connectors (B).
Disconnect the floor wire harness 2P connector (A)
from the driver's side impact sensor (B).
07YAZ-S3AA100
I
6 .
I
Advertisement
Chapters
Table of Contents
Troubleshooting
