Acura 2002 RSX Service Manual page 1386

SRS
DTC Troubleshooting (cont'd)
DTC 2-1: Open or Increased Resistance in
Front Passenger's
Airbag Inf lator
SpecialTools Required
. SRS inflator simulator 07SAZ-T84011A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-231.
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO - Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures {see
page 23-231.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnectthe front passenger's airbag 4P
connector from the dashboard wire harness {A}.
7 .
Con nect the special tool (2 0 connectors) to the
dashboard wire harness 4P connector.
Reconnect the battery negative cable.
Erase the DTC memory.
23-40
\
8. Bead the DTC.
ls DTC 2-1 indicated?
YES Go to slep 9.
NO Open or increased resistance in the front
passenger's airbag inflator; replace the front
passenger's airbag {see page 23-129).I
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the driver's airbag 4P connector (A)
from the cable reel.
Disconnect both seat belt tensioner 2P connectors
(A) from the floor wire harness.
1
' I.