Acura 2002 RSX Service Manual page 1418

SRS
1 3 .
1 4 .
t 5 _
DTC Troubleshooting {cont'dl
'11.
Disconnect SRS unit connector A (18P) from the
S R S u n i t .
Disconnect the special tool from the floor wire
harness 2P connector.
Reconnect the battery negative cable.
Turn the ignition switch ON (ll).
Check for voltage between the No. 2 terminal of
SRS unit connector A (18P) and body ground, and
between the No. 11 terminal and body ground.
There should be 0.5 V or less.
SRS UNIT CONNECTOR A {18PI
ls the voltage as specitied?
YES Faulty SRS unit; replace the SRS unit{see
p a g e 2 3 ' 1 3 8 ) . 1
NO Short to power in the floor wire harness;
replace the floor wire harness.I
23-72
l .
DTG 22-5: Short to Ground in Front
Passenger's Seat Belt Buckle Tensioner
Special Tools Required
. SRS inflator simulator 07SM-TB4ol1A
. SRS simulator lead F 07XAZ-S230100
Erase the DTC memory (see page 23-23).
Turn the ignition switch ON (ll), and checkthatthe
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23),.
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the front passenger's seat belt buckle
tensioner 4P connector (A) from the floor wire
harness.
I
6 .
7 .
-s230100
Connect the special tool (2 Q connectors) to the
floor wire harness 4P connector,
Reconnect the battery negative cable.
Erase the DTC memory.