Acura 2002 RSX Service Manual page 1398

sRs
DTC Troubleshooting (cont'd)
DTC 3-5: Short to Ground in Driver's Seat Belt
Tensioner
Special Tools Required
. sRs inflator simulator 07sAz-TB4011A
' SRS simulator lead C 07TM-S2501 1A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO - lntermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures {see
page 23-23).
3. Turn the ignition switch OFF. Oisconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's seat belt tensioner 2P
connector from the floor wire harness (A).
07TAZ-5250't1A
07sAZ-TB401rA
Connect the special tool (2 Q connector)
floor wire harness 2P connector.
to the
23-52
1 5 .
I
6. Reconnect the battery negativ6 cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 3-S indicated?
YES- Go to step 9.
NO-Shortto ground in the driver's seat belt
tensioner; replace the driver's seat belt (see page
23-4l.f
9. Turn the ignition switch oFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the floor wire harness 4P connector (A)
from the dashboard wire harness.
1 1 . Connect the special tool (2 Q connectors) to the
dashboard wire harness 4P connector.
Reconnect the battery negative cable.
Erase the DTC memory.
Read the DTC.
ls DTC 3-5 indicated?
YES- Go to step 15.
NO Short to ground in the floor wire harness;
replace the floor wire harness.l
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
12.
1 3 .
1 4 .