Acura 2002 RSX Service Manual page 1314

Keyless/Power Door Lock System
1 .
2 .
Door Lock Knob Switch Test
Remove the driver's door panel (see page 20-4).
Disconnect the 3P connector from the actuator.
Check for continuity between the No. 1 and No. 3
t e r m i n a l s :
. There should be continuity when the door lock
knob switch is in the LOCKED position.
. There should be no continuity when the door lock
knob switch is in the UNLOCKED position.
Check for continuity between the No. 1 and No. 2
terminals:
. There should be continuity when the door lock
knob switch is in the UNLOCKED position.
. There should be no continuity when the door lock
knob switch is in the LOCKED position.
It the continuity is not as specified, replace the
driver's door lock actuator.
22-162
Door Lock Switch Test
Remove the door panel (see page 20-4).
Remove the two mounting screws and the door
lock switch.
3 . C h e c k f o r c o n t i n u i t y b e t w e e n t h e N o . 1 a n d N o . 2
t e r m i n a l s :
. There should be continuity when the door lock
switch is in the LOCKED position.
. There should be no continuity when the door lock
s w i t c h i s i n t h e U N L O C K E D p o s i t i o n .
Check for continuity between the No. 2 and No. 3
t e r m i n a l s :
. There should be continuity when the door lock
switch is in the UNLOCKED position.
. There should be no continuity when the door lock
switch is in the LOCKED position.
lf the continuity is not as specified, replace the door
lock switch.
I
't.
2.