Acura 2002 RSX Service Manual page 764

Hide thumbs Also See for 2002 RSX:

Table of Contents

Shafts and Glutches

Clutch Waved-plate Phase Difference Inspection

1. Placethe clutch waved-plate (A) on a surface plate,

and set a dial indicator (B) on the waved-plate.

2. Find the bottom (D) of a phase difference ofthe

waved-plate, zero the dial indicator and make a

reference mark on lhe bottom of the waved-plate.

3. Rotate the waved-plate about 72-degrees apart

from the bottom whjle holding the waved-plate by

its circumference. The dial indicator should be at

the top (E) of a phase difference. Do not rotate the

waved-plate while holding its surface, always

rotate it with holding its circumference.

4. Read the dial indicator. The dial indicator reads the

phase difference (C) of the waved-plate between

bottom and top.

Standard: 0.05 mm {0.002 in.l minimum

5. Rotate the waved-plate about 54-degrees. The dial

indicator should be at the bottom of a phase

difference (F and H), and zero the dial indicator.

6. Measure the phase difference at the other two tops

( G a n d l ) o f t h e w a v e d - p l a t e b y f o l l o w i n g s t e p s 3

7. lf the two values of the three measu rements are

within the standard, the waved-plate is OK, lf the

two values of the three measurements are out of

the standard, replace the waved-plate.

Chapters

Table of Contents