Acura 2002 RSX Service Manual page 1415

)
1 1 . D i s c o n n e c t S R S u n i t c o n n e c t o r A ( 1 8 P ) f r o m t h e
SRS unit. Do not disconnect the special tool from
the floor wire harness 4P connector.
Check resistance between the No. 2 and No, 11
terminals of SRS unit connector A (18P). There
s h o u l d b e 2 . 0 3 . 0 0 .
J
SRS UNIT CONNECTOR
A (18PI
Wire side of female terminals
ls the resistance as specified?
YES Faulty SRS unit or poor contact at SRS unit
connector A ('l8P) and at the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 23-138).f
NO Open or increased resistance in the floor wire
harness; replace the floor wire harness.l
l
DTC 22-3: Short to Another Wire or
Decreased Resistance in Front Passenger's
Seat Belt Buckle Tensioner
Special Tools Required
. SRS inflator simulator 07SAZ-TB401 1A
. SRS simulator lead F 07XM-S230100
1. Erasethe DTC memory (see page 23-23]-.
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-231.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's seat belt buckle
tensioner 4P (A) connector from the floor wire
harness.
Connect the special tool (2 Q connectors) to the
floor wire harness 4P connector.
Reconnect the battery negative cable.
Erase the DTC memory.
(cont'd)
-s230100
6 .
1 .
23-69