Acura 2002 RSX Service Manual page 1450

sRs
7 .
DTC Troubleshooting (cont'd)
Connect the special tool (jumper connector) to the
floor wire harness 2P connector.
Disconnect SRS unit connector A (18P) from the
SRS unit.
Check resistance between the No.9 and No. 16
terminals of sRS unit connector A (18P). There
s h o u l d b e 0 1 . 0 Q .
SRS UNIT CONNECTOR A I18P}
Wire side of female terminals
ls the resistance as specified?
YES - Faulty front passenger's side impact sensor
or SRS uniU replace the front passenger's side
impact sensor (see page 23-'139). lf the problem is
still present, replace the SRS unit (see page 23-138).
t
NO - Open in the floor wire harness; replace the
f l o o r w i r e h a r n e s s . l
9 .
BLUi
:r-r
1
2 3
6
' l ' l ' l t
r l r ? l 1 E | \
10 11
GRY/RED
23-104
DTC 14-4: Faulty Power Supply to the Front
Passenger's Side lmpact Sensor
1. Erase the DTC memory (see page 23-23!.
2. Turnthe ignition switch ON (ll), and checkthatthe
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO -'lntermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23).
3. Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's side airbag and front
passenger's side airbag 2P connectors (A), and
disconnecl both seat belt buckle tensioner 4P
connectors (B).
' -