Acura 2002 RSX Service Manual page 660

Automatic Transmission
Shift Solenoid Valves Replacement (cont'd)
7 .
Disconnect the shift solenoid valve connectors.
Remove the bolts, and hold the shift solenoid valve
frody, then remove them. Do not hold the connector
to remove,
Install the new O-rings (two per solenoid valve) (F)
on the replacement solenoid valve.
6 x 1 . 0 m m
1 2 N . m
{1,2 kgf.m,
8.7lbf.ftl
9. Install shift solenoid valve C, D, and E. While
holding the shift solenoid valve body, be sure to
i n s t a l l t h e s o l e n o i d v a l v e s u n t i l t h e i r m o u n t i n g b o l t
brackets contact the servo body.
1 0 . I n s t a l l s h i f t s o l e n o i d v a l v e A a n d B . W h i l e h o l d i n g
the shift solenoid valve body, be sure to install the
solenoid valves untiltheir mounting bolt brackets
contactthe bracket of installed solenoid. Do not
i n s t a l l t h e s h i f t s o l e n o i d v a l v e A a n d B b e f o r e
i n s t a l l i n g t h e s h i f t s o l e n o i d v a l v e D a n d E . l f
s o l e n o i d v a l v e A a n d B a r e i n s t a l l e d b e f o r e
s o l e n o i d v a l v e s D a n d E , i t m a y d a m a g e t h e
hydraulic control system.
'11.
Connect the shift solenoid valve D connector (G)
with the ATF temperature sensor.
14-128
12. Connect the solenoid valve A connector (BLU wire),
s o l e n o i d v a l v e B c o n n e c t o r ( O R N w i r e ) , s o l e n o i d
v a l v e C c o n n e c t o r ( G R N w i r e ) , a n d s o l e n o i d v a l v e E
c o n n e c t o r ( R E D w i r e ) .
'13.
Install the shift solenoid valve cover with a new
gasket and dowel pins.
14. Install the ATF cooler inlet line with the line bolt
and new sealing washers. Create clearance with
the transmission jack between the transmission
and the front subframe to tighten the line bolt with
the torque wrench.
1 5 . I n s t a l l t h e b r a c k e t o f t h e A T F c o o l e r i n l e t l i n e o n t h e
shift solenoid valve cover with the bolt.
1 6 . R e m o v e t h e t r a n s m i s s i o n j a c k .
'17.
Refill the transmission with the recommended fluid
( s e e p a g e 1 4 - 1 3 9 ) .