Acura 2002 RSX Service Manual page 1434

sRs
DTC Troubleshooting (cont'd)
DTC 11-1: Open or Increased Resistance in
Driver's Side Airbag Inflator
Spacial Tools Required
. SRS inflator simulator 07SAZ-TB4011A
. SRS simulator lead E 07XM-S140200
'1.
Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to steo 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-231.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire harness 2P connector (A)
from the driver's side airbag (B).
Connect the special tool (2 Q connector) to the
floor wire harness 2P connector.
23-88
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 11-1 indicated?
YES Go to step 9.
NO Open or increased resistance in the driver's
side airbag inflator; replace the driver's side airbag
(see page 23-131). !
9. Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's side airbag 2P
connector (A) and both seat belt buckle tensioner
4P connectors (B).
I