Acura 2002 RSX Service Manual page 1423

)
)
J
7. Unbuckle the driver's seat belt.
Check resistance between the No. 1 and No.2
terminals of the driver's seat belt buckle switch 3P
connector. There should be 0 1 Q.
Check resistance between the No. 1 and No. 3
terminals of the same connector. There should be
a n o p e n c i r c u i t , o r a t l e a s t 1 M Q ,
DRIVER'S SEAT BELT
BUCKLE SWITCH 3P CONNECTOR
T e r m i n a l s i d e o f m a l e t e r m i n a l s
BLU/RED
Terminal side of male terminals
ls the resistance as specitied?
YES Go to step 8.
NO Replace the driver's seat belt buckle assembly,
and clear the DTC.I
9 .
1 0 .
8. Check resistance between the No. 1 terminal of the
floor wire harness 3P connector and body ground.
T h e r e s h o u l d b e 0 1 0 .
FLOOR WIFE HARNESS 3P CONNEgTOR
Wire side o{ female terminals
ls the resistance as specified?
YES Go to step 9.
NO- Open in the floorwire harness or poor ground
connection at G501. lf G501 is OK, replace the floor
w i r e h a r n e s s . I
Disconnect the negative cable from the battery.
Disconnect the SRS unit connector B (8P) from the
S R S u n i t .
{cont'd)
23-77