Acura 2002 RSX Service Manual page 1205

Under-dash Fuse/Relay Box
Removal and Installation
SRS components are located in this area. Review the
SRS component locations (see page 23-10) and
precautions and procedures (see page 23-1 1) in the SRS
section b€fore performing repairs or service.
Removal
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the radio's
preset buttons.
2. Disconnect the battery negative cable. then
disconnect the positive cable, and wait at least 3
minutes.
3. Remove the dashboard lower cover (see page 20-
6 1 ) .
4. Disconnectthe connectors from the fuse side ofthe
under-dash fuse/relay box.
5. Remove the mounting bolt and slide the under-
dash fuse/relay box {A) down from the bracket (B).
6, Disconnect the connectors from the back of the
under-dash fuse/relay box, and remove the fuse/
retay oox.
NOTE: The SRS connector is a spring-loaded lock
type (see page 23-15).
lnstallation
'1. Install the under-dash fuse/relay box in the reverse
order of removal and connect all connectors to the
under-dash f use/relay box.
2. lnstall the dashboard lower cover.
3. Connect both the negative cable and positive cable
to the battery.
4. Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
5. Confirm that all systems work properly.
22-53