Acura 2002 RSX Service Manual page 1001

Glass
1 0 .
Ouarter Glass Replacement (cont'dl
lf the old quarter glass is to be reinstalled (and
either clip is broken off the molding), seal the body
holes with pieces of urethane tape (A). Then set the
quarter glass upright in the opening, and make
alignment marks (B) across the quarter glass and
body with a grease pencil at the three points shown.
Be careful not to touch the quarter glass where
adhesive will be applied.
1 1 . R e m o v e t h e q u a r t e r g l a s s .
-u --
2A-34
12. With a sponge, apply a light coat of glass primer to
the inside face of the quarter glass (A) as shown,
then lightly wipe it off with gauze or cheesecloth:
. Do not apply body primer to the quarter glass,
and do not get the body and glass primer
sponges mixed up.
. Never touch the primed surfaces with your hands.
lf you do the adhesive may not bond to the
quarter glass properly, causing a leak after the
quarter glass is installed.
. Keep water, dust, and abrasive materials awav
from the orimed surface.
l,/;/)///,, I Apptv stas;sv imer here.
t
/\
l f 7
1 2 m m t
' l l
10.47 in.l I
fl ,.^
-
1),3'
Inside I I
L L
m m
- ' : '
Rrstr:-.;