Acura 2002 RSX Service Manual page 1440

sRs
DTG Troubleshooting {cont'd)
DTC 12-1: Open or Increased Resistance in
Front Passenger's Side Airbag Inflator
Special Tools Required
. SRS inflator slmulator 07SAZ-T84011A
. SRS simulator lead E 07XAZ-S140200
1. Erase the DTC memory (see page 23-231.
2. Turn the ignition switch ON {ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO- Intermiftent failure, system is OK at this time.
Go to Troubleshooting lntermittent Failures (see
page 23-23t.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire harness 2P connector {A)
from the front passenger's side airbag (B).
07xAz-s1A02(x)
07sAz-T84011A
\_
F.C
LJ
23-94
5. Connect the special tool (2 0 connector) to the
floor wire harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 12-1 indicated?
YES- Go to step 9.
NO Open or increased resistance in the front
passenger's side airbag inflator, replace the front
passenger's side airbag {see page 23-131).1
9. Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
10. Disconnect the driver's side airbag 2P connector (A)
and both seat belt buckle tensioner 4P connectors
( B ) .
I