Acura 2002 RSX Service Manual page 1447

q
7. Connect the special tool (iumper connector) to the
floor wire harness 2P connector.
8. Disconnect SRS unit connector A (18P) from the
S R S u n i t .
Check resistance between the No.8 and No. 15
terminals of SRS unit connector A (18P). There
s h o u l d b e 0 - 1 . 0 0 .
SRS UN]T CONNECTOR A {18PI
BRA
2 3
I t l a l s l i
t 0
l 1 I
; l r o l r z L r a l
\
RED/YEL
Wire side of female terminals
ls the resistance as specitied?
YES Faulty driver's side impact sensor or SRS
unit; replace the driver's side impact sensor {see
page 23-139). llthe problem is still present. replace
t h e S R S u n i t ( s e e p a g e 2 3 - 1 3 8 ) . 1
NO-Open in the floor wire harness; replace the
floor wire harness.l
)
.;*
)
DTC 13-4: Faulty Power Supply to the Driver's
Side lmpact Sensor
1. Erasethe DTC memory (see page 23-231.
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SBS indicator staY on?
YES - Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's side airbag and front
passenger's side airbag 2P connectors {A), and
disconnect both seat belt buckle tensioner 4P
connectors (B).
(cont'd)
23-101