Acura 2002 RSX Service Manual page 1468

sRs
24.
25.
SRS Indicator Circuit Troubleshooting (cont'dl
Reconnect the battery negative cable.
Connect a voltmeter between the No. 3 terminal
( + ) of SRS unit connector C (18P) and body ground.
Turn the ignition switch ON (ll), and measure rhe
voltage. There should be battery voltage.
sRs uNlT coI{t{EcToR c tl 8P}
Wire side oI lemale terminals
Is there battery voltage?
YES Go to step 29.
NO Go to step 26.
Turn the agnition switch OFF.
Disconnectthe dashboard wire harness 2P
connector lAlfrom the under-dash fuse/relay box.
26.
2 7 .
23-122
Check resistance between the No. 3 terminal of
SRS unit connector C (18P) and the No. 2 terminal
ofthe dashboard wire harness 2P connector- There
should be 0 1.0 O.
DASHBOARD YVIRE HARI{ESS 2P CONNECTOR
Wire side of
female
Wire side of female terminals
ls the resistance as specilied?
YES Open in the under-dash fuse/relay box or
poor contact at the dashboard wire harness 2P
connector; check the connection. lfthe connection
is OK, replace the under-dash fuse/relay box.!
NO Open in the dashboard wire harness; replace
the dashboard wire harness.l
29. Turn the ignition switch OFF.
30. Disconnect SRS unit connector B (8P) from the SRS
unit.
I
-
J
sRs uNfT cot{]{EcToR c trSPl