Acura 2002 RSX Service Manual page 1362

sRs
Precautions and Procedures (cont'd)
Backprobing Spring-loaded Lock Connectors
When checking voltage or resistance on this type of
connector the first time, you must remove the retainer
to insert the tester probe from the wire side.
NOTE: lt is not necessarv to reinstall the removed
retainer; the terminals will stay locked in the connector
h o u s i n g .
To remove the retainer (A). insert a flat-tip screwdriver
(Bl between the connector body and the retainer, then
carefully pry out the retainer. Take care not to break the
connector.
23-16
Seats with Side Airbags
Seats with side airbags have a
"SIDE AIRBAG" label on
the seat-back. Because the component parts (seat-back
cover, cushion, etc.) of seats with and without airbags
are different, make sure you install only the correct
replacement parts.
SIDE AIRBAG
When cleaning, do not saturate the seat with liquid,
and do not spray steam on the seat,
Do not repair a torn or frayed seat-back cover.
Reolace the seat-back cover.
After a collision in which the side airbag was
deployed, replace the side airbag with new parts. lt
the seat-back cushion is split, it must be replaced. lf
the seat-back frame is deformed, it must be replaced.
Never put aftermarket accessories on the seat (covers,
pads, seat heaters. lights, etc.).