Acura 2002 RSX Service Manual page 1435

11. Disconnect SRS unit connector A (18P) from the
SRS unit. Do not disconnect the special tool from
the floor wire harness 2P connector.
Check resistance between the No. 6 and No. 17
terminals of SRS unit connector A (18P). There
should be 2.0 - 3.0 Q.
SRS UN]T CONNECTOR A (18PI
12.
WHT/BLU
r--r-4
l l l s I s l f t
l 1 6 l 1 7 l 1 0
| \
l
2
3
10
l l
WHT
ar-x I
Wire side of female terminals
ls the resistance as specilied?
YES Faulty SRS unit or poor contact at SRS unit
connector A (18P) and the SRS unit. Check the
connection; ifthe connection is OK, replace the
SRS unit (see page 23-138).f
NO-Open or increased resistance in the floor wire
harness; replace the floor wire harness.l
DTC 11-3: Short to Another Wire or
Decreased Resistance in Driver's Side Airbag
lnflator
Special Tools Required
. SRS inflator simulator 07SAZ-TB4011A
. SRS simulator lead E 07XAZ-S140200
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (lll, and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stav on?
YES-Go to step 3.
NO Intermittent failure, sYstem is OK at this time
Go to Troubleshooting Intermiftent Failures (see
page 23-231.
3. Turn the ignition switch OFF. Disconnectthe
baftery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire harness 2P connector (A)
from the driver's side airbag (B).
5. Connect the special tool (2 Q connector) to the
floor wire harness 2P conneclor
6. Reconnectthe battery negative cable.
7. Erase the DTC memory.
(cont'd)
23-89