Acura 2002 RSX Service Manual page 992

Scrape or wipe the excess adhesive off with a putty
knife or towel. To remove adhesive from a painted
surface or the windshield. wipe with a soft shop
towel dampened with alcohol.
Let the adhesive dry for at least t hour, then spray
water over the windshield and check for leaks.
Mark leaking areas, and let the windshield dry, then
seal with sealant:
. Let the vehicle stand for at least 4 hours after
windshield installation. lf the vehicle has to be
used within the first 4 hours. it must be driven
slowly.
. Keep the windshield dry for the first hour after
installation.
24. Reinstall the cowl covers.
25. On both sides of the windshield. set the bottom
edge of the side molding (A) under the cowl cover
(B). and set the hook (C) under the front fender (D).
then align the clips {E, F)with the retainers (G).
Push on the clip portions of the molding until the
molding is fully seated on the windshield.
26. Reinstall all remaining removed parts.
NOTE: Advise the customer not to do the following
things for 2 to 3 days:
. Slam the doors with all the windows rolled up.
. Twist the body excessively {such as when going
in and out of driveways at an angle or driving
over rough, uneven roads).
20-25