Table of Contents
Advertisement
sRs
DTC Troubleshooting (cont'd)
DTC 1-5: Short to Ground in Driver's Airbag
lnflator
Special Tools Required
. SRS inflator simulator 07SAZ-TB401t A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off,
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23).
Turn the ignition switch OFF. Disconnect the
battery negative cable. and wait for 3 minutes.
Disconnect the driver's airbag 4P connector from
the cable reel (A).
TB4O11A
Connect the special tool (2 Q connectors) to the
cable reel 4P connector,
Reconnect the battery negative cable.
Erase the DTC memory.
6.
7 .
23-38
I
8. Read the DTC.
ls DTC 1-5 indicated?
YES- Go to step 9.
NO-.Short to ground in the driver's airbag inflator;
replace the driver's airbag (see page 23-127).1
9. Disconnect the battery negative cable, and wait for
3 m i n u t e s .
10. Disconnectthe front passenger's airbag 4P
connector {A)from the dashboard wire harness.
1 1 .Disconnect both seat belt tensloner 2P connectors
(Alfrom the floor wire harness.
Advertisement
Chapters
Table of Contents
Troubleshooting
