Acura 2002 RSX Service Manual page 664

Automatic Transmission
1 .
2 .
A/T Clutch Pressure Control Solenoid Valves B and C Replacement
R e m o v e t h e a i r c l e a n e r h o u s i n g .
Disconnect the A/T clutch pressure control solenoid
valves B and C connectors.
Remove the mounting bolts, harness clamp
brackets (A), and the A,/T clutch pressure control
solenoid valves B and C.
6 x 1 . 0 m m
12 N.m ('1.2 kgt.m,8.7 lbf.ft)
4. Remove the ATF joint pipes (D), O-rings (E), and
gasket (F).
3 .
14-132
5. Clean the mounting surface and fluid passages of
the A,/T clutch pressure control solenoid valves B
and C and transmission housing.
6. Clean the filter ot the ATF joint pipes.
7. Install the new gasket on the transmission housing,
and install the ATF joint pipes.
8. Install the new O-rings over the ATF joint pipes.
9. Install the new A"/T clutch pressure control solenoid
valves B and C, and harness clamp brackets.
10. Check the A,/T clutch pressure control solenoid
valves B and C connectors for rust, dirt, or oil, then
connect them securely.
1 1 . I n s t a l l t h e a i r c l e a n e r h o u s i n g .