Acura 2002 RSX Service Manual page 1401

J
1 1 . D i s c o n n e c t S R S u n i t c o n n e c t o r A ( 1 8 P ) f r o m t h e
SRS unit. Do not disconnect the special tool from
the floor wire harness.
Check resistance between the No. 1 and No. 10
terminals of SRS unit connector A (18P). There
s h o u l d b e 2 . 0 - 3 . 0 Q .
SRS UNIT CONNECTOR
A I18PI
lsthe tesistance as specif ied?
YES Faulty SRS unit or poor contact at SRS unit
connector A (18P) and the SRS unit. Check the
connection; if the connection is OK, replace the
S R S u n i t { s e e p a g e 2 3 - 1 3 8 ) . 1
NO Open or increased resistance in the floor wire
harness: reDlace the floor wire harness.l
Wire side of female terminals
4 .
DTC 21-3: Short to Another Wire or
Decreased Resistance in Driver's Seat Belt
Buckle Tensioner
Special Tools Required
. SRS inflator simulator 07SAZ-T84011A
. SRS simulator lead F 07XAZ-S230100
L Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and checkthatthe
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator staY on?
YES - Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-231.
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the driver's seat belt buckle tensioner
4P connector from the floor wire harness 4P
connector (A),
07sAz-TB401rA
Connect the special tool (2 Q connectors) to the
floor wire harness 4P connector.
Reconnect the battery negative cable.
Erase the DTC memory.
(cont'd)
6 .
7 .
23-55