Acura 2002 RSX Service Manual page 1444

sRs
1 2 .
1 3 .
DTC Troubleshooting (cont'd)
11. Disconnect SRS unit connector A (18P) from the
S R S u n i t .
Turn the ignition switch ON (ll).
Check for voltage between the No. 7 terminal of
SRS unit connector A (18P) and body ground, and
between the No. 18 terminal and body ground.
There should be 0.5 V or less.
SRS UNIT CONNECTOR A {18PI
ls the voltage as specitied?
YES-Faulty SRS unit; replace the SRS unit (see
p a g e 2 3 - 1 3 8 ) . I
NO Short to power in the floor wire harness;
replace the floor wire harness.l
23-98
DTC 12-5: Short to Ground in Front
Passenger's Side Airbag Inflator
Special Tools Required
. SRS inflator simulator 07SAZ-TB4011A
. SRS simulator lead E 07XM-S140200
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-231.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4, Disconnect the floor wire harness 2P connector (A)
from the front passenger's side airbag {B).
07xAz-s1A0200
Connect the special tool (2 Q connector) to the
floor wire harness 2P connector.
l , ;