Acura 2002 RSX Service Manual page 1394

sRs
DTC Troubleshooting (cont'd)
DTC 3-3: Short to Another Wire or Decreased
Resistance in Driver's Seat Belt Tensioner
Special Tools Required
. SRS inflator simulator 07SAZ-T84011A
. SRS simulator lead C 07TAZ-S2501 14
. SRS simulator lead F 07XAZ-S230100
1. Erasethe DTC memory (see p age 23-231.
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SBS indicator stay on?
YES Go to step 3.
NO- Intermiftent failure. system is OK at this time.
Go to Troubleshooting lntermittent Failures (see
page 23-23).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's seat belt tensioner 2P
connector from the floor wire harness (A).
07TAZ-S25011A
07SAZ-TB.r011A
Connectthe specialtool (2 Q connector)
floor wire harness 2P connector.
to the
23-48
t c .
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 3-3 indicated?
YES Go to step 9.
NO-Short in the driver's seat belttensioner;
replace the driver's seat belt (see page 23-4),1
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the floor wire harness 4P connector (A)
from the dashboard wire harness.
Connect the special tool (2 O connectors) to the
dashboard wire harness 4P connector.
Reconnect the battery negative cable.
Erase the DTC memory.
Read the DTC.
ls DTC 3-3 indicated?
YES Go to step 15.
NO - Shon in the floor wire harness; replace the
floor wire harness.l
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
1 1 .
12.
1 3 .
1 4 .
qffiE.-
i--11lts*-
07SAZ-T84011A
-:-:J,,