sRs
32.
33.
DTG Troubleshooting (cont'dl
Turn the ignition switch OFF.
Disconnect the OPDS unit harness 8P connector (A)
from the OPDS unit (B) (see page 23-140).
34. Turn the ignition switch ON (ll)
Does the side aitbag cutoll indicator come on?
YES Go to slep 35.
NO Faulty OPDS unit; replace the OPDS unit. t
35. Turn the ignition switch OFF.
36. Remove the gauge assembly (see page 22-66), then
disconnect gauge assembly connector B (18p)from
the gauge assembly.
23-114
37. Check resistance between the No. 8 terminal of
gauge assembly connector B (18P) and body
ground. There should be an oDen circuit, or at least
1 M 0 .
GAUGE ASSEMBLY CONNECTOR B {18PI
Wire side of female terminals
ls the rcsistance as specified?
YES Short to ground in the side airbag cutoff
indicator circuit; replace lhe gauge assembly.t
NO Short to ground in the dashboard wire
harness A, the floor wire harness, or the OPDS unit
harness; replace the faulty harness.l
I