Acura 2002 RSX Service Manual page 1465

)
The SRS Indicator Stays On When In "SCS"
Menu Method
NOTE:
. lf you cannot retrieve DTCS with the PGM Tester
using the SCS menu method, retrieve the flash codes
with the Tester in SCS mode (see page 23-211.
. A new SRS unit must sense the entire svstem is OK
before completing its initial self-test. The most
common cause of an incomplete self-test is the
failure to replace all deployed parts after a collision.
in Darticular, seat belt tensioners and seat belt buckle
tensioners.
. An incomplete self-test prevents the PGM Tester from
retrieving DTCS. although flash codes are available in
the Tester's SCS mode.
1. Erase the DTC memory using the MES connector
(see page 23-23).
Does the SRS indicalor go otl while you erase the
DTC memory?
YES Go to step 42.
NO Go to steD 2.
2. Checkthe No. l3 (10A) fuse inthe under-dash
fuse/relay box.
ls the f use OK?
YES - Go to steD 19.
NO Go to steD 3.
3. ReDlace the No. l3 (10A) fuse in the under-dash
fuse/relay box.
4. Turn the ignition switch ON (ll). and wait for 30
seconds. Then turn the ignition switch OFF.
5. Check the No. 13 (10A) fuse in the under-dash
fuse/relav box.
ls the f use OK?
YES The svstem is OK at this time.l
NO Go to step 6-
)
o .
7 .
Replace the No. 13 (10A) fuse in the under-dash
fuse/relay box.
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the driver's airbag 4P connector (A).
Disconnect the front passenger's airbag 4P
connector (A).
q
(contd)
23-119