Acura 2002 RSX Service Manual page 1003

Glass
1 6 .
Ouarter Glass Replacement (cont'dl
Use suction cups (A) to hold the quarter glass (B)
over the opening, align the clipsor the alignment
marks (C) made in step 10, and set it down on the
adhesive. Lightly push on the quaner glass until its
edges are {ully seated on the adhesive all the way
around. Do not open or close the doors until the
adheasive is drv.
17. Scrape or wipe the excess adhesive off with a putty
knife or towel. To remove adhesive from a oainted
surface or the quarter glass, wipe with a soft shop
towel damaged with alcohol.
18. Let the adhesive dry for at least t hour,then spray
water over the quaner glass and check for leaks.
Mark the leaking areas and let the quarter glass dry,
then seal with sealant. Let the vehicle stand for at
least 4 hours after quarter glass installation. lf the
vehicle has to be used within the first 4 hours. it
must be deriven slowy.
19. Reinstall all remaining removed parts.
NOTE: Advise the customer not to do the following
things for 2 to 3 days:
. Slam the doors with all the windows rolled up.
. Twist the body excessively (such as when going
in and out of driveways at an angle or driving
over rough, uneven roads).
20-36
\