Acura 2002 RSX Service Manual page 1370

SRS
General Troubleshooting Information (cont'dl
Initializing the OPDS (Occupant Position Detection Systeml Unit
Spedal Tools Bequired
SCS service connector 07PAZ-0010100
When the seat-back cover, seat-back cushion, and/or OPDS unit are replaced, initialize the OPDS system by following
the procedure below.
NOTE: Make sure the passenger's seat is dry. Set the seat-back in the normal position, and make sure there is nothing
on the front passenger's seat.
1. Make sure the ignition switch is OFF.
2. Connect the Honda PGM Tester (A) to the DLC (16P) (B), and follow the Tester's prompts in the "SCS" menuto
ground the SCS line (see the Honda PGM Tester Operator's Manuar,.
3. Connect the SCS service connector (A) to the MES connector (2P) (B). Do not use a iumoer wire.
4 . T u r n t h e i g n i t i o n s w i t c h O N ( l l ) .
5. The SRS indicator comes on for about 6 seconds and goes off. Remove the SCS service connector from the MES
connector within 4 seconds after the SRS indicator went off.
6. The SRS indicator comes on again. Reconnect the SCS service connector to the MES connector within 4 seconds
after the SRS indicator comes on.
7. The SRS indicator goes off. Remove the SCS service connector from the MES connector within 4 seconds.
8. Watch the SRS indicator.
' l f t h e i n d i c a t o r b l i n k s t w o t i m e s a n d t h e n s t a y s o n , t h e O P D S i s i n i t i a l i z e d , b u t t h e D T C S n e e d t o b e e r a s e d . G o t o
step 9, then erase the DTCS.
. l f t h e i n d i c a t o r b l i n k s t w o t i m e s a n d t h e n g o e s o f f , t h e O P D S u n i t i s i n i t i a l i z e d . G o t o s t e p 9 .
. l f t h e i n d i c a t o r s t a y s o n w i t h o u t f i r s t b l i n k i n g , t h e O P D S i s n o t i n i t i a l i z e d . R e a d t h e D T C , a n d g o t o t h e
appropriate page in the DTC Troubleshooting Index.
9. Turn the ignition switch off, and disconnect the PGM Tester.
SBS indicator
MES
23-24
OISCONNECTEO