Acura 2002 RSX Service Manual page 1406

sRs
DTC Troubleshootin g (cont'd)
DTC 4-1: Open or Increase Resistance in Front
Passenger's Seat Belt Tensioner
Special Tools Required
. SRS inflator simulator 07SAZ-T84011A
. SBS simulator lead C 07TAZ-S25011A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll). and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to steo 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's seat belt
tensioner 2P connector from the floor wire harness.
AZ-S25011A
Connect the special tool (2 Q connector) to the
floor wire harness 2P connector.
23-60
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 4-l indicated?
YES- Go to step g.
NO-Open or increased resistance in the front
passenger's seat belt tensioner; replace the front
passenger's seat belt (see page 23-4). t
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the floor wire harness 4P connector (A)
from the dashboard wire harness.
ffid
_--...-..-w
07xAz-s230100
1 1 .
07SAZ-TB,I011A
Connect the special tool (2 Q connectors) to the
dashboard wire harness 4P connector.
Reconnect the battery negative cabte.
Erase the DTC memory.
Read the DTC.
ls DTC 4-1 indicated?
YES Go to step 15.
NO-Open or increased resistance in the floorwire
harness; replace the floor wire harness.l
12.
1 3 .
1 4 .