Acura 2002 RSX Service Manual page 1392

sRs
DTC Troubleshooting (cont'dl
DTC 3-1: Open or Increased Resistance in
Driver's Seat Belt Tensioner
Special Tools Bequired
. SRS inflator simulator 07SM-TB4011A
. SRS simulator lead C 07TAZ-S2501 1A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to steD 3.
NO Intermittent failure, svstem is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-231.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4, Disconnectthe driver's seat belttensioner 2P
connector from the floor wire harness {A).
07TAZ-S25011A
TB4O11A
5 .
07sAz-
6 1 |
t--tI
Connectthe specialtool (2 Q connector) to the
floor wire harness 2P connector.
23-46
t 5 .
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC,
ls DTC 3-1 indicated?
YES Go to step 9.
NO-Open or increased resistance in the driver's
seat belt tensioner; replace the driver's seat belt
(see page 23-4). I
9. Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
10. Disconnect the floor wire harness 4P connector (A)
from the dashboard wire harness.
1 1 . Connect the special tool (2 0 connectors) to the
dashboard wire harness 4P connector.
Reconnect the battery negative cable.
Erase the DTC memory.
Read the DTC.
ls DTC 3-1 indicated?
YES Go to step 15,
NO Open or increased resistance in the floor wire
harness; replace the floor wire harness.l
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
1 2 .
1 4 .
['- t&.-
---41
I iiT r-
OTSAZ-TB,|011A \
:-:!f