Acura 2002 RSX Service Manual page 1422

SRS
DTG Troubleshooting (cont'd)
DTC 9-3: Faulty Driver's Seat Belt Buckle
Switch
'1. Erase
the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), then buckle and
unbuckle the driver's seat belt several times.
3. Read the DTC.
ls DTC 9-3 indicated?
YES- Go to step 4.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23),.
4. Turn the ignition switch OFF.
23-76
5. Disconnect the floor wire harness 3P connector {A)
from the driver's seat belt buckle switch.
Buckle the driver's seat belt.
Check resistance between the No. 1 and No.3
terminals of the driver's seat belt buckle switch 3P
connector. There should be 0 - 1 Q.
Check resistance between the No. 1 and No.2
terminals of the same connector, There should be
an open circuit, or at least 1 M O .
DRIVER'S SEAT BELT BUCKLE SWITCI{
3P CONNECTOR
Terminal side of male terminals
Terminal side ot male terminals
Are the rcsistance readings as specitied?
YES Go to step 7.
NO - Replace the driver's seat belt buckle assembly,
and clear the DTC. t
I
I