Acura 2002 RSX Service Manual page 1414

sRs
v
DTC Troubleshooting (cont'd)
DTC 22-1: Open or Increased Resistance in
Front Passenger's Seat Belt Buikle Tensioner
SpecialTools Required
. SRS inflator simulator 07SAZ-T84011A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see p age 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO lntermittent fail ure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-23).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's seat belt buckle
tensioner 4P connector (A) from the floor wire
harness.
-s230100
Connect the special tool (2 Q connectors) to the
floor wire harness 4P connector.
23-68
I
6. Reconnectthe battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 22-1 indicated?
YES Go to step 9.
NO Open or increased resistance in the front
passenger's seat belt buckle tensioner; replace the
front passenger's seat belt buckle.I
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect both side airbag 2P connectors (A) and
the driver's seat belt buckle tensioner 4P
connector (B).
I
I