Acura 2002 RSX Service Manual page 1412

sRs
DTC Troubleshooting (cont'd)
DTG &5: Short to Ground in Front Passenger's
Seat Belt Tensioner
SpecialTools Required
. SRS inflator simulator 07SAZ-TB4011A
. SRS simulator lead C 07TM-S25011A
. SRS simulator lead F 07XAZ-S230100
1. Erase the DTC memory (see page 23-23).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the s?s indicator stay on?
YES Go to step 3.
NO Intermittent failure. system is OK at this time.
Go to Troubleshooting lntermittent Failures (see
page 23-23l,.
3. Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's seat belt
tensioner 2P connector from the floor wire
h a r n e s s { A } .
AZ-S25011A
5 . Connect the special tool (2 I connector) to the
floor wire harness 2P connector.
Reconnect the battery negative cable.
Erase the DTC memory.
6.
7 .
23-66
8. Read the DTC.
ls DTC 4-S indicated?
YES Go to step 9.
NO Short to ground in the front passenger's seat
belt tensioner; replace the front passenger's seat
belt (see page 23-4). t
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the floor wire harness 4P connector (Al
from the dashboard wire harness.
(=b
_-----LJ
07xAz-s230100
1 2 .
07sAz-T94011A
11. Con nect the special tool {2 Q connectors}to the
dashboard wire harness 4P conneclor.
Reconnect the battery negative cable.
Erase the DTC memory.
14. Read the DTC.
ls DTC 4-5 indicated?
YES Go to step 15.
NO Short to ground in the floor wire harness;
r e p l a c e t h e f l o o r w i r e h a r n e s s . l
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.