Viewing Ip Connectivity - AudioCodes Mediant 800B User Manual

Parameter
IP Address
State

46.12 Viewing IP Connectivity

The IP Connectivity page displays on-line, read-only network diagnostic connectivity
information on all destination IP addresses configured in the Outbound IP Routing Table
page (see ''Configuring Outbound IP Routing Table'' on page 369).
Note: he information in columns 'Quality Status' and 'Quality Info' (per IP address) is
reset if two minutes elapse without a call to that destination.

To view IP connectivity information:
1. In the Routing General Parameters page, set the 'Enable Alt Routing Tel to IP'
parameter (AltRoutingTel2IPMode) to Enable or Status Only (see ''Configuring
General Routing Parameters'' on page 369).
2. Open the IP Connectivity page (Status & Diagnostics tab > VoIP Status menu > IP
Connectivity).
Column Name
IP Address The IP address can be one of the following:


User's Manual
Routing Rules on page 515)

Not Used = Proxy server isn't defined.

IP address and FQDN (if exists) of the Proxy server with which the
device currently operates.

N/A = Proxy server isn't defined.

OK = Communication with the Proxy server is in order.

Fail = No response from any of the defined Proxies.
Figure 46-10: IP Connectivity Page
Table 46-5: IP Connectivity Parameters
IP address defined as the destination IP address in the Outbound IP
Routing Table.
IP address resolved from the host name defined as the destination IP
address in the Outbound IP Routing Table.
644
Mediant 800B Gateway and E-SBC
Description
Description
Document #: LTRT-10278