On The Fly Cleaning - Oce CS9065 User Manual

5.6.2.2 On the fly cleaning

While printing, it could be possible that some nozzles drop out, in that case, perform a little, normal or
powerful cleaning.
Please follow the 4 steps below to perform a cleaning.
Step 1 : Go to the "Printing menu"
Step 2 : Press the [F2] button on the operation panel when following is displayed :
Step 3 : Select the heads to be cleanded.
•
Select the heads with the [F1] key.
•
The current head selection will be displayed in the lower right corner of the display.
•
To deselect one or more heads, select the concerned head again. It will disappear from
the list.
F1 To select head
F2 Choose which heads need to be cleaned (ALL, head 1, 2, 3, 4, 5, 6, 7 or 8)
F3 Little, normal or a powerful cleaning?
Step 4 : Press the [ENTER] key to start the cleaning procedure.
A little cleaning takes about 1 minute.
A normal or powerful cleaning take about 2 minutes.
* Printing*
Dist.Adj.
F3 A: T B: T C: T D:T
Wait Init.
*Cleaning*
F1 Select head
F3 Normal
Cleaning
rest 1 min
Cleaning
Heat Sys.
ALL
- 1 2 3 4 5 6 7 8 -
153
Chapter 5 : Handling the printer
F2
F2
Selected heads
End of the on-the-fly cleaning procedure
AP-75037, Rev. 1.1, 24/04/2006