Testprinting - Oce CS9065 User Manual

4.7 TESTPRINTING

Follow the 7 steps below to do a test print and confirm if your printer operates correctly.
Step 1 : Turn the power of the unit ON and load the media.
Step 2 : Make sure that your printer is in normal status.
Press either the [MENU ↑] key or [MENU ↓] key on the operation panel.
Step 3 :
The setup menu is displayed.
Step 4 : Press the [F3] key on the operation panel.
•
"TestPrint: SetupPrint" is displayed on the LCD.
Step 5 : Select an item and press the appropriate key.
1.1.1.1.2 Setup Key name
items
Test Print (1/2) F1
F2
F3
F4
Test Print (2/2) F1
F2
Step 6 : Print the information on the selected item.
Step 7 : After printing, the printer returns to the normal status.
* SetupMenu *
InkStatus
F3 →
TestPrint
* TestPrint *
F1 → Setup
F3 → Adj. Uni-D
* TestPrint *
F1 → Palette
Parameters
Setup
Nozzle Check
Adj. Uni-D
Adj. Bi-D
Palette
Maintenance
Ready to print
Heaters
Cut&Feed
User1
OriginSet
MediaSet
(1/6)
NozzleCheck
Adj. Bi-D
(1/2)
Maintenance
(2/2)
Descriptions
Perform Setup List.
Refer to 4.7.1 Setup List (page 63)
Perform Nozzle check.
Refer to 4.7.2 NozzleCheck (page 64)
Perform Alignment for the uni-direction printing.
Refer to 4.7.3 Alignment (page 65)
Perform Alignment for the bi-direction printing.
Refer to 4.7.3 Alignment (page 65)
Perform Colour Palette.
Refer to 4.7.4 Colour palette (page 66)
Perform Maintenance record.
Refer to 4.7.5 Maintenance record (page 67)
Cleaning
Lever Up
xxxm
62
Chapter 4 : Preparing for a job
← F2
← F4
← F2
End of the testprinting procedure
AP-75037, Rev. 1.1, 24/04/2006